is this a good first layer? - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

hi. i just got done with a 47hr print which has a similar 1st layer to the one i'm showing here. the previous model was pretty stringy, the 1st layer is somewhat uneven feeling on the bottom, but other than that it's printed fairly well for 47hrs! so this is another component of the 47hr print, t

is this a good first layer? - Improve your 3D prints - UltiMaker

3D Printing Troubleshooting: All Problems & Solutions

3D-Print Guide 3D Prima - 3D-Printers and filaments

First layer being printed with blemishes - UltiMaker 3D printers

Print is unacurate in the first layer - Improve your 3D prints

Supports first layer is not right - UltiMaker Cura - UltiMaker

Retraction: Just say No to oozing

Guide to Ironing: How to make top surfaces super smooth with

is this a good first layer? - Improve your 3D prints - UltiMaker

Best 3D printers for 2024

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Strange Pattern in first layer - Improve your 3D prints