it seems like PETG absorbs moisture crazy fast, these two prints are on the same printer about 10hrs apart on a rainy day. Can the spool be dried? (black stuff is ink

New to 3D printing! Help why does my PETG look absolutely terrible : r/3Dprinting

Top 3 Mistakes you can do in PETg Printing, don't make them too!

Petg bubbling and tearing : r/FixMyPrint

International Full Line Catalog 2020 by Demco, Inc. - Issuu

SOLVED] Bad quality when printing PETG - Bambu Lab X1 Series - Bambu Lab Community Forum

Rite in the Rain Waterproof Printer Sheets, 8.5 x 11, No.6511

Are those bubbles caused by moisture in my PETG? I printed this pieces with my usual PETG settings I've never had problem with. I thought it was the bed leveling but it's

Getting better! Most of the improvement comes from drying the PETG then storing it with dessicant : r/FixMyPrint

2024 Spectrum Elementary Education Catalogue English - Flipbook by cknapp

Printing PETG is a disaster! : r/FixMyPrint

Wet PETG on the left side (about 60 to 70% humidity in the room) and dry filament on the right. I aborted the print and dried the filament for about 6 hours

Filament popping noise, not extruding cleanly. Anyone had similar? Petg 245 degrees, btt skr mini e3 2.0 noticed this after upgrading boards. Filament is dry, pid tuned and nozzle/hot end cleaned.

Why is my PETG filament coming off the bed and cracking during the print? : r/3Dprinting

How To Dry Your Filament

Wet PETG on the left side (about 60 to 70% humidity in the room) and dry filament on the right. I aborted the print and dried the filament for about 6 hours at 130 deg F in a makeshift food dehydrator, then restarted the print and the results are evident. : r