Mesh inflation layer not shown - Project Support - SimScale CAE Forum

Hi all, I am currently trying to inflate boundary layer of 1st layer < 1e-5. When I try to make the inflation layer smaller, the layer did not grow. I tried using both relative and absolute size and also played with the advance options. Can you give me some feedback on what I did wrong? From the mesh log, I can see that the inflation layer is as intended and after “Selecting externalDisplacementMeshMover displacementMedialAxis” there is some iteration that causes the layer not to grow. This

Inflation does not follow edge of airfoil

Week 3 - External flow simulation over an Ahmed body.

7 Questions to Ask CAE Vendors of Structural Analysis and Simulation Software

Which is the best CFD software? - Quora

Design and Analysis of Generic UAV Composite Winglet Structures

speed regulation on motorways

What is a SolidWorks simulation worker agent? - Quora

SimScale - Another Fine Mesh

播放列表 playList-7a8e6569-bece-4ade-a8b7-ce0e91a38e0c