Malco Right Angle Drive Access (For HC1/2) – Roofing Tool Shop

Works well with HC1 and HC2 Hole Cutters. May be used to help cut take-off holes in sheet metal duct-work suspended below floor joists or for take-offs from the side of large trunk lines where reaching up and cutting at 90° is desirable.

Works well with HC1 and HC2 Hole Cutters. May be used to help cut take-off holes in sheet metal duct-work suspended below floor joists or for

Malco Right Angle Drive Access (For HC1/2)

Bosch Drill Parts & Attachments at

The Malco Adjustable Hole Cutter works with almost any power drill to make 2 - 12 inch diameter holes in sheet metal. It features a durable cutter bit

Adjustable Hole Cutter

Cuts 2-12 (51-305 mm) holes in sheet metal including up to 20 gauge galvanized steel Commonly used by HVACR and Roofing Professionals Combination

Malco HC1 2 in. to 12 in. Sheet Metal Hole Cutter Accessory for 1/4 in. or Larger Drill, Multi

Malco HC1B Pivot Pin Set for HC1 and HC2 Cutters, Silver (1 per Pack) - Hand Tool Punches

Malco Power Tool Accessories at

HVAC – Roofing Tool Shop

Malco Right Angle Drive Access (For HC1/2) – Roofing Tool Shop

Malco Right Angle Drive Access (For HC1/2) – Roofing Tool Shop

Edmondson Supply Malco Tools HC1 Adjustable Sheet Metal Hole Cutter, 2 - 12